![]() And/or there could be Thunderbolt problems, perhaps. Change User: to root, set Event: to Boot-Up. Control Panel -> Task Scheduler -> Create -> Triggered Task -> User Defined Script. Other apps would be Mountain Duck, ExpanDrive. fredbert said: iMazing (which I used in preference to iTunes/Finder). Automounter might be good until Synology get their act together. I think most were resolved by the time of Big Sur, but I've not yet tried Monterey myself, nor do I use an M1 system, so not sure if there might be new issues. For this to persist through reboots, you will need to add scheduled task that runs under root at boot time. And what Synology said wed get in Macs client for Drive v3, but thats been sliding faster than an Olympic bobsleigher. SMB or Server Message Block is a Microsoft Windows technology so it stands to reason that sharing links to SMB shares (or as Microsoft calls them, network shares) is baked into the OS. After further troubleshooting and working with Sophos (endpoint protection) they think. Unfortunately, this is not how macOS works. There have been bugs and slowdowns in macOS in the past related to network connectivity speeds. This also has to do with Opportunistic Locking on Mac OS Big Sur. If the same files definitely are OK when accessed from Windows over gigabit, then that might point to a macOS problem. If your BRAW files are lower resolution and/or framerate, the bandwidth requirement would be lower. Same applies for 5:1 constant bitrate at that resolution and FPS, but 8:1 and 12:1 would be OK. Store files to Synology NAS from a Mac computer within the local network Overview Synology NAS is designed to make storing and sharing files within your local network quick and simple, allowing you to directly access shared folders and files on the Synology NAS without going through the hassle of logging into DSM everytime. For example, a BRAW of 4608x2592 (4.6K) 30 fps using 3:1 constant bitrate requires 183 MB/s bandwidth, which is 1464 Mbit/s - too much for Gigabit. ![]() That may or may not be enough, depending on the bitrate used in your BRAW files. Set the proper rights on the file “/etc/auto_nfs”.When you're accessing the NAS on Windows, are you also doing so over Gigabit Ethernet? I have that same Caldigit TB3+ Hub, and it's only a 1GBit/s connection. ![]() CPU speed between 100MHz and 2 As for the Synology, we can only hope that yhe. nfs://192.168.200.200:/volume1/nfs_volume, the location of the NFS volume 0+ and iOS 11+ as well as Windows 10 and MacOS High Sierra The R390x in my.noowners,nolockd,resvport,hard,bg,intr,rw,tcp,nfc,rsize=8192,wsize=8192, the mounting parameters where the parameter “resvport” was required to connect to the NFS volume on my Synology.Change /username/nfs_volume to match your user name and the location where you want the volume to be visible in your local file system. /username/nfs_volume, the location where you want to mount the volume.Replace with the value from the table above. macOS versionĬreate the file “/etc/auto_nfs” and use the template below as an example for your settings. Mentioned as one of the breaking changes, the base mount-path changed changed in macOS Catalina 10.15. ![]() net -hosts -nobrowse,hidefromfinder,nosuid This will try to auto-mount your nfs drive. Add the “auto_nfs”-line to the end of the file.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |